Parallel Fasteners
Ideal for fastening two parallel aluminium profiles at a distance of 12mm. Both halves of the spring loaded fastener engage in the profile grooves facing each other. This fixes the profiles in position. The fastener is then clamped by tightening an internal screw.
Parallel Fastener 8
0.0.476.58
Flat Brackets
Flat brackets are suitable for connecting and attaching cable conduits, Support and Wall Profiles, panel elements or any other components.
Bracket 5 20 flat, white aluminium, similar to RAL 9006
0.0.677.76
Bracket 6 30 flat, white aluminium, similar to RAL 9006
0.0.677.74
Bracket 8 40 flat, white aluminium, similar to RAL 9006
0.0.666.35
Bracket 8 120×40 flat, white aluminium, similar to RAL 9006
0.0.687.82
Universal Butt Fasteners
These can be used to connect the end faces of two aluminium profiles. The sets should always be used in pairs.
Universal-Butt-Fastening Set 8, bright zinc-plated
0.0.265.46
Automatic Butt Fasteners
These can be used to connect the end faces of two aluminium profiles from the same line without machining. The fastener is screwed into a profile groove in the end face, cutting the thread automatically.
The sets should always be used in pairs.
Automatic Butt-Fastening Set 5, bright zinc-plated
0.0.464.19
Automatic Butt-Fastening Set 6, bright zinc-plated
0.0.419.74
Automatic Butt-Fastening Set 8, bright zinc-plated
0.0.406.80
Mitre Butt Fasteners
Suitable for connecting the end faces of two aluminium profiles at an angle. They are used primarily when constructing frames and panel edging.
The profile grooves facing each other inside the frame remain unobstructed so they can be used for holding panel elements.
Mitre-Butt-Fastening Set 6
0.0.606.47
Mitre-Butt-Fastening Set 8
0.0.492.25
Cable Holds
The three options below provide a particularly easy means of securing cables to aluminium profiles. A simple cable tie holds the cable in place.
Universal Holder 8, black
0.0.494.52
Universal Holder
0.0.418.24
Holder for Cables and Hoses 8
0.0.196.65
Table Top Fasteners
A strong fastening element for table tops made of solid wood, chipboard or similar. The self-tapping screw can be screwed directly into the table top using a screwdriver (TX30 Bit). Clamping in the profile groove is achieved by tightening the self-tapping screw.
Table Top Fastening Set 8
0.0.617.63
Ball Joints
Create a flexible connection with a strong hold.
Ball Joint 8, Ball End 40×40
0.0.610.95
Ball Joint 8, Socket with Clamp Lever
0.0.611.00
Limit Switch Holders
Fasten Limit Switches to profiles or other components with these Limit Switch Holders. When the anti-torsion block is used, Limit-Switch Holder D18 can be attached in 10° increments relative to the Profile 8 groove. Without anti-torsion blocks, attachment is possible at any angle.
Limit Switch Holder D18
0.0.411.30
Limit Switch Holder D12
0.0.406.42